Sunday, December 25, 2011

nerf spectre mod

                                                     Today I'm going to show how to mod a Nerf spectre.

                                                                we will start by opening the gun.
Now unscrew the 5 screws on the bottom of the barrel.
Now pull theses out.
Throw this stuff in the garbage.
Cut here with pliers.
Place whats left back in the barrel.
Screw everything back together and your done.
                                      

6 comments:

  1. Quite helpful, thanks for this.

    ReplyDelete
  2. look at that video you found for me, http://www.youtube.com/watch?v=hJtrMWjnhxg, when ur cutting off that plastic part, cut out the center too, that should help more.. right?

    Jim101

    ReplyDelete
    Replies
    1. No, people just say cutting the supports out helps!

      Delete
    2. The blaster has a small reverse plunger and a pretty terrible air seal, so cutting the ARs doesn't do too much without a plunger tube replacement and/or a rubber/foam turret seal. You can cut off the plunger tube air outlet and glue rubber or foam sheeting to it to get a near-perfect seal. Also, you can put a spring (AR spring works) under the grey piece in front of the barrels. This will push the whole turret back towards your plunger tube, improving you seal slightly. Just a few more things to get the most out of your Spectre!

      Delete
    3. I did this mod long time ago, I know what to do now. Thanks anyways

      Delete

Let Me Know What You Think!